ONKYO TX-SR574 User Manual
50
Advanced Setup
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as
fied as
Small
in the “Speaker Configuration” on page 35.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers.
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers.
Notes:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly.
and set accordingly.
• Choose a higher crossover frequency if you want more
sound from your subwoofer.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can only be set
if in the Speaker Configuration on page 35, the Sub-
woofer setting is set to Yes (step 3), and the Front setting
is set to Large (step 4).
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can only be set
if in the Speaker Configuration on page 35, the Sub-
woofer setting is set to Yes (step 3), and the Front setting
is set to Large (step 4).
Advanced Speaker Settings
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
MODE button, followed by the
[SETUP] button.
2
Use the Up and Down [
]/[
]
buttons to select “2. SP Config,”
and then press [ENTER].
and then press [ENTER].
3
Use the Down [
] button to
select “Crossover,” and then use
the Left and Right [
the Left and Right [
]/[
] but-
tons to select a crossover fre-
quency.
quency.
Use the diameter of the smallest
speaker in your system when choosing
the crossover frequency.
speaker in your system when choosing
the crossover frequency.
The Crossover Frequency, Double Bass, and
Speaker Distance settings cannot be changed
while a pair of headphones is connected,
speaker set B is on, or the multichannel DVD
input is being used.
Speaker Distance settings cannot be changed
while a pair of headphones is connected,
speaker set B is on, or the multichannel DVD
input is being used.
SETUP
RECEIVER
*Choose the setting suitable for the speaker.
Continue with step 4 of the “Double
Bass” setting below.
Bass” setting below.
4
Use the Down [
] button to
select “Double Bass,” and then
use the Left and Right [
use the Left and Right [
]/[
]
buttons to select:
On:
Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
right channels is also fed to
the subwoofer (default).
Off:
Double Bass function off.
5
Press the [SETUP] button.
Setup closes.
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
40/50/60Hz*
6-1/2 to 8 in.
(16–20 cm)
80Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100Hz (default)
3-1/2 to 5-1/4 in.
(9–13 cm)
120Hz
Under 3-1/2 in.
(9 cm)
150/200Hz*
SETUP
TX-SR574_En.book Page 50 Wednesday, April 5, 2006 5:14 PM