Panasonic WR-XS3P User Manual
11
System Configuration
Decide what kind of system to form. Determine the num-
ber of the external devices, the connection form, and the
mode (p. 14 Unit Modes and Signal Flow).
ber of the external devices, the connection form, and the
mode (p. 14 Unit Modes and Signal Flow).
d
Connections
Connect the components to the unit.
d
Settings
Configure the following settings:
• Modes (pp. 14 to 17)
• Input line assignment (if using the SUB OUT jack) (p.
• Input line assignment (if using the SUB OUT jack) (p.
18)
• Output line assignment to MULTI IN/LINE IN.(p. 19)
d
Sticking a Label (p. 26)
Stick the supplied label on each component.
d
Adjusting the Input and Output Levels (pp. 29 to 31)
Adjust the input and output levels with the knobs on the
front panel.
front panel.
d
Attaching/detaching the acrylic cover (p. 28)
Attach the acrylic cover on the unit front panel to prevent
wrong operation.
wrong operation.
INSTALLATION
■
Work Flow
■
Before Installation
Caution:
Contact your dealer for installing the unit.
Be sure to toggle the power off and unplug the unit from
the receptacle before installation. Follow the safety
instructions.
Be sure to toggle the power off and unplug the unit from
the receptacle before installation. Follow the safety
instructions.
●
Power Connection
Connect the power cord by any of the following methods,
making sure to provide a breaking device in each case.
making sure to provide a breaking device in each case.
(1) Connect the power cord to the power control unit.
(2) Install the unit near a receptacle and connect the power
(2) Install the unit near a receptacle and connect the power
cord to the receptacle via a breaking device. The
breaking device should be installed near an operator.
breaking device should be installed near an operator.
(3) Connect the power cord to a circuit breaker in a panel
board that has a contact distance of 3.0 mm or more.
Use a circuit breaker that will interrupt each circuit of
the main power supply (except a ground-protective
conductor).
Use a circuit breaker that will interrupt each circuit of
the main power supply (except a ground-protective
conductor).
●
Installation Place
• Install the unit out of direct sunlight and away from out-
lets of heated air. Installation in a humid, dusty or shaky
place may cause trouble.
place may cause trouble.
• Keep a distance between this unit and a transformer,
dimmer, image device, CRT monitor, etc. as much as
possible. Failure to do this may cause induction noise.
possible. Failure to do this may cause induction noise.
●
Rack Mounting
Keep the temperature in the rack below 45 °C . Failure to
do this may cause damage to internal components.
do this may cause damage to internal components.
●
Grounding the Unit
Ground the unit by the grounding terminal at the rear side.
If the devices are connected in unbalanced connections,
synchronize each grounding potential as follows:
If the devices are connected in unbalanced connections,
synchronize each grounding potential as follows:
• Synchronize the power supply phases.
• Synchronize the power supply lines.
• Connect each device's grounding terminal or chassis
• Synchronize the power supply lines.
• Connect each device's grounding terminal or chassis
with a thick grounding wire of each device.
Failure to do this may cause induction noise.
Note:
If the unit is placed more than 10 m away from
other external devices, grounding the unit near an unbal-
anced external device is recommended.
anced external device is recommended.
●
Condenser Microphone
• When using a condenser microphone, connect it to an
external device.
• Do not connect external devices supplying phantom
power, as it may damage the unit.