Panasonic WR-XS3P User Manual
13
■
Cable Information
The usable cable types, plugs, and connectors are the following.
Before connection, sure you are using the proper cables.
Before connection, sure you are using the proper cables.
Screw (x3)
Spring washer
2
3
1
(COLD)
(HOT)
(GND)
HOT
GND
HOT(Tip)
COLD(Ring)
GND(Sleeve)
GND
H (HOT)
C (COLD)
3
2
1
HOT
HOT
GND
●
Pin plug
●
Tip-ring-sleeve (TRS) phone plug
●
XLR connector (XLR3-12 type)
Caution:
No.2 pin of the XLR connector of this unit is hot. When connecting a device whose No.3 is hot, connect No.2 pin (No.3 pin)
of this unit to No.3 pin (No. 2 pin) of the device.
of this unit to No.3 pin (No. 2 pin) of the device.
Notes:
• Be sure to use shielded wire for audio input/output lines.
• Use a cable of less than 10 m length for a high-impedance microphone. High-pass loss can occur if the cable capacity is
• Use a cable of less than 10 m length for a high-impedance microphone. High-pass loss can occur if the cable capacity is
insufficient.
Use a cable less than 50 m when using a low-impedance microphone (150
Use a cable less than 50 m when using a low-impedance microphone (150
Ω
, 250
Ω
or 600
Ω
).
• Keep speaker lines away from input lines. Failure to do this may cause unstable operation and shaking.