ONKYO 29400086 User Manual

Page of 43
En-
10
Connecting the Speakers
Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker 
wiring polarity. Connect positive 
(+) terminals to only positive (+) 
terminals, and negative (–) 
terminals to only negative (–) 
terminals. If the speakers are 
wired incorrectly, the sound will 
be out of phase and will sound unnatural.
• Be careful not to short the positive and negative wires. 
Doing so may damage your amp.
Use the supplied speaker cables to connect 
each speaker input terminals to the 
corresponding speaker output terminals on 
your receiver.
Match the color of each cable to the corresponding 
speaker terminal.
To make a connection, while pressing the 
terminal lever, insert the wire into the 
hole, and then release the lever. Make 
sure that the terminals are gripping the 
bare wires, not the insulation.
Using the supplied RCA cable, connect the 
subwoofer’s LINE INPUT to your receiver’s PRE 
OUT: SUBWOOFER.
HT-S7200: If you are using an Onkyo HT-S7200 
system, you can connect the powered subwoofer with 
two PRE OUT: SUBWOOFER jacks respectively. When 
using a single subwoofer, you can connect either jack. 
The other jack is for connecting additional subwoofer.
Speaker Connection Precautions
Connecting the Speaker Cables
Connecting the Subwoofer
Red
White
Blue
Green
Front right
speaker
Center speaker
Gray
Brown
Tan
Front left
speaker
Surround
back right
speaker
Surround
back left
speaker
Surround
right
speaker
Surround
left
speaker
Powered
subwoofer
HTP-770_EnFrEs.book  Page 10  Wednesday, July 29, 2009  10:07 AM