ONKYO 29400086 User Manual

En-

8

Before you connect the speakers, attach the supplied 
speaker base to each SKF-770.
1. Turn the speaker upside down with the protection 

cover attached.

2. Align the speaker base while the arrow mark 

 is 

headed in the same direction as the speaker’s face.
Be careful not to tip over the speaker.

3. Align the screw holes on the speaker base with 

those on the bottom of each speaker, and affix the 
speaker base using the supplied screws. 
Recommended torque is 10 kgf·cm (9 lbf·in).
Be careful not to tip over the speaker.

4. Turn the speaker right side up.
5. Remove the protection cover.

SAFETY PRECAUTIONS:
• Attach the speaker bases in a manner that will not 

allow the speakers to tip over.

• Be sure to tighten the screws when you attach the 

speaker bases.

• Attach the speaker bases on a flat, level, and stable 

floor.

• After you attach the speaker bases, make sure that the 

speakers stand upright and are stable.

Top of SKF-770

Protection cover

Supplied screws

Speaker base

Bottom of SKF-770

Arrow mark

HTP-770_EnFrEs.book  Page 8  Wednesday, July 29, 2009  10:07 AM