Samson L1212 User Manual

ENGLISH

4

1.   Titanium Compression Driver – 1.75 inch (44mm), 

titanium diaphragm with 1 inch opening. 

2.   Wide Dispersion Horn  – 1 inch throat, 60 x 90 degree 

wide dispersion horn provides extensive coverage and 

linear off- axis response.

3.   Power LED – Blue Light Emitting Diode illuminates 

indicating the unit is powered on and ready for 

operation. 

4.   Low Frequency Driver -  12-inch and 15-inch woofers 

with oversize motors and large voice coils deliver deep, 

controlled bass response.

5.   Handle – One of two over sized carry handles.
6.   Bass Port– Precision tuned, low frequency port extends 

the bass response.

7.   Steel Grill – Durable steel grill provides protection for, 

and easy access to LF driver.

8.     Enclosure – Rigid, all-plywood enclosure for maxmum 

output and durability.

Amplifier Panel Rear View
 9.   Heat sink - Convection cooling of the internal power  

amplifier via massive aluminum extrusion.

10.   LINE INPUT connector - XLR Input for connecting 

balanced line level signals.

11.   LINE OUTPUT connector- Male XLR connector used 

to link multiple LIVE series.

12.   AMP / CLIP LED - Dual color LED lights Green when 

amp is active, flashes Red when the amp is clipped or 

stays Red indicating the amplifier is in protect mode.

13.    LINE LEVEL – Used to control the level of the line 

input.

14.  POWER – Switches on the LIVE series’ main power.
15.   VOLTAGE switch - Used to change the operating 

voltage from 115 to 230 volts.  

IMPORTANT NOTE! Bure sure to confirm and install the 

properly rated fuse when changing the operating voltage. 

(See below AC Power Inlet).
16.   AC Power inlet  / Fuse Sled– Connect the supplied 

standard IEC AC power cable here.