Anchor Audio AN-100CMF1+ User Manual

MADE IN USA

SIX YEAR WARRANTY

AN-1000X+ Speaker Monitor Owners Manual

USING YOUR WIRELESS MICROPHONES
After you have set the transmitter channel (see above) you are ready to use your wireless microphone:

1.  Body-pack transmitter users must insert  

the mic plug into the transmitter jack marked 
MIC

2.  Push the transmitter power button for two sec-

onds until ON (The red LED will stay on when 
the mic is turned on. If the red LED flashed, the 
battery is low)

3.  Turn the AN-1000X+ power switch to ON
4.  The RX indicators will light 

(only one indicator  

will light at a time) when the wireless signal is  
being transmitted and received

OPERATING THE WIRELESS MICROPHONE/TRANSMITTER

REPLACE BATTERY - HANDHELD TRANSMITTER

1.  Unscrew battery cover on bottom of microphone
2.  Replace old batteries with two fresh size ‘AA’  

alkaline batteries

3.  Replace battery cover and tighten firmly

CAUTION:  Harmful feedback may occur when walking in front of a sound system or speaker with a wireless microphone.  Always point microphone away from speakers.

CHANNEL SELECTION - HANDHELD TRANSMITTER

1.  Unscrew battery cover on bottom of microphone
2.  Set the CHANNEL SELECTOR dial to match the channel setting  

of your receiver

3.  Replace battery cover and tighten firmly

NOTE:  When using dual wireless, each microphone must be set to a different channel.

CHANNEL SELECTION - BODY-PACK TRANSMITTER
  1.  The channel selection dial is located on the side of the transmitter
  2.  Set the CHANNEL selection dial to match the channel setting of  

 

the receiver

REPLACE BATTERY - BODY-PACK TRANSMITTER

1.  Slide open battery cover on front of transmitter
2.  Replace old batteries with two fresh size ‘AA’ 

alkaline batteries

3.  Replace battery cover by sliding firmly into place