JVC CA-DXJ35 User Manual
4
~
TV/monitor
• To select progressive scanning mode (see page 6), use
COMPONENT jacks.
• Connect the VIDEO jack, S-VIDEO jack, or
COMPONENT jacks; whichever you want to use.
• You can get better picture quality in the order—
Composite video
]
S-Video
]
Component video.
Ÿ
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
• If the antenna cord is covered with vinyl on the tip, twist and
pull the vinyl off to remove.
For better FM reception
• Disconnect the supplied FM antenna, and connect an
outdoor FM antenna using a 75
Ω
wire with coaxial type
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
!
Powered subwoofer
• Before plugging the powered subwoofer to the main unit,
make sure that the powered subwoofer is turned off or at
minimum volume.
minimum volume.
• The subwoofer output level varies follow to the System
master volume.
Green
Blue
Red
S-Video cord
(not supplied)
(not supplied)
Composite video
cord (supplied)
cord (supplied)
Component video cord (not supplied)
Extend it so that you can obtain the best
reception.
reception.
AM loop antenna (supplied)
Turn until the best reception is
obtained.
obtained.
FM antenna (supplied)
FM outdoor antenna
(not supplied)
(not supplied)
Audio Cord
(not supplied)
(not supplied)
From the powered
subwoofer (not supplied)
subwoofer (not supplied)
DX-J35[U].book Page 4 Thursday, April 26, 2007 4:41 PM