Delphi Gateway Systems Analysis INterface Tool (SAINT) User Manual

 

4.3.2 

Gateway Reports 

The gateway will report a Reset whenever one occurs.  Most likely causes of reset are power on reset, host 
commanded reset, or gateway micro watchdog error.  The gateway does a cold start on all resets (all information is 
lost). The gateway will also report error conditions with the Report Error message below.  See section 4.3.2.1 for 
error code definitions.  

The gateway will also echo back all system commands.  

08h 

80h 

Reset Occurred 

None 

08h 

82h 

Report Error 

1 byte Error Code 

08h 

86h 

Report Time Stamp Information OFF 

None 

08h 

87h 

Report Time Stamp Information ON 

None 

08h 

88h 

Report Transmit Echo ON  

None 

08h 

F0h 

Report Gateway Trigger ON 

None  

08h 

F1h 

Report Gateway Trigger OFF 

None 

4.3.2.1 

Gateway Error Codes 

Most error codes are related to sending data at the wrong rate (usually too fast). 

80h 

System - Invalid message ID  

81h 

System - RS-232 Transmit Buffer Full 

82h 

System - UART Error (Overrun, etc.) 

83h 

System – Received message is too long. 

84h 

System - Have not read previous message