JL Audio SB-S-IMPRZA/10W6v2 Leaflet
INSTALLATION
D I F F I C U L T Y :
D I F F I C U L T Y :
I N S T A L L A T I O N G U I D E
for the
SB-S-IMPRZA/10W6v2
SB-S-IMPRZA/10W6v2
2002 - Up
2002 - Up Subaru Impreza Sedans
Subaru Impreza Sedans
(will not fit sport wagons)
(will not fit sport wagons)
Thank you for choosing a JL Audio Stealthbox
®
for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox
®
installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 1 year if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox
the Stealthbox
®
be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
or sudden deceleration.
S T E P 1
Remove the heavy carpet flooring from the trunk.
Flip over the thin underlying carpeting, as shown in the
picture at the right.
Remove the heavy carpet flooring from the trunk.
Flip over the thin underlying carpeting, as shown in the
picture at the right.
Continued on Next Page
S T E P 2
Locate and remove the round sticker that covers an exsisting
factory hole. The sticker will be painted the same color as the
exterior of the vehicle.
Locate and remove the round sticker that covers an exsisting
factory hole. The sticker will be painted the same color as the
exterior of the vehicle.
S T E P 3
Enlarge this factory hole, using an Uni-bit® or 1/2-inch
drill bit.
Enlarge this factory hole, using an Uni-bit® or 1/2-inch
drill bit.
Note: Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling!
to be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling!
SB-S-IMPRZA/10W6v2_INSTR_SKU#011218
SB-S-IMPRZA/10W6v2_INSTR_SKU#011218
2
5
OUT
OF
OF