Mitsubishi Electronics MR-J2-03A5 User Manual
1 - 4
1. FUNCTIONS AND CONFIGURATION
1.5 Parts Identification
Used to set parameter
data.
data.
Used to change the
display or data in each
mode.
display or data in each
mode.
Used to change the
mode.
mode.
Refer To
Chapter6
Name/Application
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
The four-digit, seven-segment LED shows the servo
status and alarm number.
UP
DOWN
SET
I/O signal connector (CN1A)
Used to connect digital I/O signals.
Used to connect digital I/O signals.
Name plate
Servo motor connector (CNP2)
Connector for connection of the servo motor.
Connector for connection of the servo motor.
Power input connector (CNP1)
Used to connect the input power supply/control circuit
power supply/RS-422.
Used to connect the input power supply/control circuit
power supply/RS-422.
Earth (E) terminal ( )
To conform to the EN Standard, fit the supplied earth
terminal for grounding.
To conform to the EN Standard, fit the supplied earth
terminal for grounding.
Operation section
Used to perform status display, diagnostic, alarm and
parameter operations.
Used to perform status display, diagnostic, alarm and
parameter operations.
Chapter6
Section3.3
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Used to connect digital I/O signals.
Section3.3
Section1.3
Communication connector (CNP3)
Used for connection with a personal computer
(RS-232C).
Used for connection with a personal computer
(RS-232C).
Section3.9
MODE
Section10.2.1
Section3.3
Section12.1.1
Section10.2.1
Section3.3
Section10.2.1
Section3.3
Section12.1.3