ZyXEL Communications 3.1 User Manual

 Chapter 8 Route

ZyWALL (ZLD) CLI Reference Guide

The ZyWALL has no knowledge of the networks beyond the network that is directly connected to the 
ZyWALL. For instance, the ZyWALL knows about network N2 in the following figure through 
gateway R1. However, the ZyWALL is unable to route a packet to network N3 because it doesn't 
know that there is a route through the same gateway R1 (via gateway R2). The static routes are 
for you to tell the ZyWALL about the networks beyond the network connected to the ZyWALL 
directly.

Example of Static Routing Topology

The following table describes the commands available for static route.

 

You must use the 

configure terminal

 command to enter the configuration mode before you can use these 

commands. See 

 for information on input values.  

Command Summary: Static Route

[no] ip route {w.x.y.z} {w.x.y.z} {interface|w.x.y.z} 

<0..127>

Sets a static route. The no command deletes a static 
route.

ip route replace {w.x.y.z} {w.x.y.z} {interface|w.x.y.z} 

<0..127> with {w.x.y.z} {w.x.y.z} {interface|w.x.y.z} 

<0..127>

Changes an existing route’s settings.

show ip route-settings

Displays static route information. Use show ip route 
to see learned route information. See 

.

ip6 route destv6/prefix { ipv6_global_address | 

ipv6_link_local | interface} [<0..127>]

Sets an IPv6 static route.

ip6 route destv6/prefix { ipv6_link_local interface} 

[<0..127>]

Sets an IPv6 link local static route.

no ip6 route destv6/prefix { gatewayv6 | interface} 

[<0..127>]

Deletes the specified IPv6 static route.

ip6 route replace destv6/prefix { gatewayv6 | interface} 

[<0..127>] with destv6/prefix { gatewayv6 | interface} 

[<0..127>]

Changes an existing IPv6 route’s settings.