Siemens SIMATIC 505 User Manual
Installation
2-7
Series 505 High Speed Counter
and Encoder Module User
and Encoder Module User
’s Manual
2.3
Inserting the Module in the I/O Base
The HSC is a single-wide module. Insert it into any available slot on any
Series 505 I/O base. Do not touch the printed circuit board while inserting
the module. This could cause electrostatic damage to the components on
the board. Insert the module as shown in Figure 2-3.
Series 505 I/O base. Do not touch the printed circuit board while inserting
the module. This could cause electrostatic damage to the components on
the board. Insert the module as shown in Figure 2-3.
!
To minimize potential shock, turn off power to the I/O base and any
modules installed in the base before inserting or removing a module.
Failure to do so may result in potential injury to personnel or damage to
equipment.
modules installed in the base before inserting or removing a module.
Failure to do so may result in potential injury to personnel or damage to
equipment.
Base Plane
Connectors
Connectors
3 ĂĂ
Ă(2.6
ĂĂ)Ă maxĂ
Figure 2-3
Inserting the Module into the I/O Base