Siemens SIMATIC 505 User Manual
2-8
Installation
Series 505 High Speed Counter
and Encoder Module User
’s Manual
2.4
Wiring the Module
2.4.1
Wiring the
Wiring the
Wiring the module consists of wiring the the input and output signals.
Terminal Block
See Figure 2-4 and Figure 2-5 for general guidelines. All connections are
made at the module terminal block. See Figure 2-5. Output returns for
Channel 1 and 2 are internally connected.
made at the module terminal block. See Figure 2-5. Output returns for
Channel 1 and 2 are internally connected.
Use the Terminal Block Worksheet in Appendix B for planning your wiring.
!
Turn off power to the I/O base and any modules installed in the base
before inserting or removing a module. Failure to do so may cause
potential injury to personnel or can damage equipment.
before inserting or removing a module. Failure to do so may cause
potential injury to personnel or can damage equipment.
2.4.2
Powering Up
Powering Up
After wiring the terminal block for the HSC, restore power to the
the Module
base.
1 cm
(0.4 in.)
Wire Gauge: 22–16
Max. Width: 5.54 mm (
.
218 in.)
Stud Size: #4 (2.5mm)
Amp Part#: 321462
Amp Part#: 321462
Max. Width: 4.62 mm (
.
182 in.)
Stud Size: #4 (2.5mm)
Amp Part#: 327891
(Specify 2pt. connector)
Amp Part#: 327891
(Specify 2pt. connector)
Figure 2-4
Wiring Guidelines