Sony DVX-11B User Manual
33
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
Power
No power is being supplied to the unit.
• The power connection has not been made
correctly.
t Check the connection. If everything is in
t Check the connection. If everything is in
order, check the fuse.
• The car does not have an ACC position.
t Insert a disc to turn on the unit.
Picture
There is no picture/picture noise appears.
• A connection has not been made correctly.
• Check the connection to the connected
• Check the connection to the connected
equipment, and set the input selector of the
equipment to the source corresponding to
this unit.
equipment to the source corresponding to
this unit.
• The disc is dirty, flawed, or deteriorated.
• The unit is installed at an angle of more than
• The unit is installed at an angle of more than
20°.
• The unit is not installed in a sturdy part of
the car.
• The monitor is connected to the FRONT
AUDIO/VIDEO OUT, and the parking cord
(Light green) is not connected to the parking
brake switch cord, or the parking brake is not
applied.
(Light green) is not connected to the parking
brake switch cord, or the parking brake is not
applied.
Picture does not fit in the screen.
The aspect ration is fixed on the DVD.
Sound
There is no sound/sound skips/sound
cracks.
cracks.
• A connection has not been made correctly.
• Check the connection to the connected
• Check the connection to the connected
equipment, and set the input selector of the
equipment to the source corresponding to
this unit.
equipment to the source corresponding to
this unit.
• The disc is dirty, flawed, or deteriorated.
• The unit is installed at an angle of more than
• The unit is installed at an angle of more than
20°.
• The unit is not installed in a sturdy part of
the car.
• The unit is in pause playback mode, or in
slow playback mode.
• The unit is in fast forward mode, or in fast
reverse mode.
• The settings for the outputs are not made
correctly.
Sound is noisy.
Keep cords and cables away from each other.
Sound distortion occurs.
Set “AUDIO ATT” in “AUDIO SETUP” to
“ON” (page 29).
“ON” (page 29).
The sound volume is low.
Set “AUDIO ATT” in “AUDIO SETUP” to
“OFF” (page 29).
“OFF” (page 29).
Operation
The remote does not function.
• There are obstacles between the remote and
the unit, or the remote receptor.
• The distance between the card remote
commander and the unit is too far.
• The card remote commander is not pointed
at the remote sensor, or the receptor on the
unit properly.
unit properly.
• The batteries in the card remote commander
are weak.
The unit does not respond.
t Press the reset button.
The contents of the settings have been
erased.
erased.
• The reset button is pressed.
• The battery has replaced, or the power cord
• The battery has replaced, or the power cord
is disconnected.
• The power connection has not been made
correctly.
No beep sound when pressing buttons.
t Set “BEEP” in “CUSTOM SETUP” to
“ON” (page 28).
A disc cannot be loaded.
• Another disc is already loaded.
• The ignition key switch of the car is set to the
• The ignition key switch of the car is set to the
OFF position.
The unit does not start playing.
• The disc is inserted upside down.
t Insert the disc with the playback surface
down.
• The disc inserted is not applicable.
• The DVD inserted is not applicable due to
• The DVD inserted is not applicable due to
the region code.
• Moisture has condensed inside the unit.
• The DVD-R, DVD-RW, CD-R, or CD-RW
• The DVD-R, DVD-RW, CD-R, or CD-RW
inserted is not finalized.
continue to next page
t