Clarion DXZ385USB User Manual

 

DXZ385USB

● Adjusting the treble

This adjustment can be performed only when 
the Z-Enhancer Plus is set to “CUSTOM ”.

2-1. Select “TREBLE”.

3-1. Press the [w] or [z] button to select as 

following order.

“TREB<G>” ↔ “TREB<F>”

∗

The factory default setting is “TREB<G>”.

3-2. Press the [

] button.

3-3. Press the [w] or [z] button to adjust the 

gain, the F (center frequency) and the Q.

:The factory default setting is “0”.

(Adjustment range: +7 to 

–

7)

: The factory default setting is 

“10k”.

(Adjustment range:
10k/12.5k/15k/17.5k)

3-4.  Press the [

] button to return to the 

previous mode.

● Adjusting the balance

2-1. Select “BALANCE”.

3-1. Press the [w] or [z] button to adjust the 

balance of the right and left speakers.

∗

The factory default setting is “CENTER” 
(center). (Adjustment range: RIGHT12 to 
LEFT12 (right 12 to left 12))

● Adjusting the fader

2-1. Select “FADER”.

3-1. Press the [w] or [z] button to adjust the 

balance of the rear and front speakers.

∗

The factory default setting is “CENTER” 
(center). (Adjustment range: FRONT12 to 
REAR12 (front 12 to rear 12))

● Setting the subwoofer

You can set the low pass filter of subwoofer.

2-1. Select “S-W LPF”.

3-1. Each time press the [w] or [z] button to 

select the setting, the setting changes in 
the following order: 

“THROUGH” ↔ “LPF 50” ↔ “LPF 80” ↔ 
“LPF 120”

∗

The factory default setting is 

“THROUGH

”.

● Adjusting the subwoofer output 

You can adjust the volume output from the unit’s 
subwoofer output terminal.

This adjustment can be performed only when 
the “S-W LPF” is set to “LPF 120”, “LPF 80” or 
“LPF 50”.

2-1. Select “S-W VOL”.

3-1. Press the [w] or [z] button to increases 

or decreases the subwoofer volume.

∗

The factory default setting is 

“0

”. 

(Adjustment range: +6 to –6)

∗

When the volume level is more than 30, the 
subwoofer volume adjustment value can not 
reach +6.

● Adjusting the high pass filter

2-1. Select “HPF”.

3-1. Each time you press the [w] or [z] button 

to select the setting.

The setting changes in the following order: 
“120” 

↔

 “THROUGH”

∗

The factory default setting is “THROUGH” 
(through).

∗

This is supported only with amplifiers 
equipped with this function. Output is not 
supported from RCA cables.

The MAGNA BASS EXTEND does not adjust 
the low frequencies like the normal sound 
adjustment function, but emphasizes the deep 
bass frequencies to provide you with a dynamic 
sound.

∗

The factory default setting is “OFF” (off).

1. Press and hold the [SOUND] button for 1 

second or longer to turn on the MAGNA 
BASS EXTEND effect. “M-B EX” appears in 
the display for 2 seconds.

2. Press and hold the [SOUND] button for 1 

second or longer to turn off the MAGNA 
BASS EXTEND effect.