Snapper 1733866 User Manual

Component Installation

Figure 6. Lower Chute to Boot Installation
A. Pin, Latch
B. Carriage Bolt, 1/4-20 x 5/8
C. Locknut, 1/4-20
D. Lower Chute
E. Locknut, Center Lock, 5/16-18
F. Strap, Rubber
G. Locknuts, Whiz Lock, 5/16-18
H. Rod, Boot Mount
I.

Capscrew, Hex Head, 5/16-18 x 1-1/4

J. Capscrew, Hex Head, Thin, 5/16-18 x 1

LOWER CHUTE ROD AND PIN INSTALLATION

1. Insert the head of pin (A, Figure 6) through front hole

of lower chute (D). Secure with 1/4-20 x 5/8 carriage
bolt (B) and 1/4-20 lock nut (C) as shown.

2. Install the rod (H) to lower chute (D) using 5/16-18 x

1 capscrew (J) and 5/16-18 locknut (G) for front
holes. Use 5/16-18 x 1-1/4 capscrew (I) and 5/16-18
locknut (G) as shown. Tighten hardware.

3. Install the rubber strap (F) onto capscrew (I) securing

with 5/16-18 locknut as shown.

Figure 7. Handle to Tube Installation
A. Handle
B. Locknuts, KEPS, 1/4-20
C. Screw, Slotted, 1/4-20 x 1/2
D. Screw, Slotted, 1/4-20 x 1
E. Strap, Rubber
F. Locknut, Center Lock, 1/4-20

HANDLE INSTALLATION

1. Install handle (A, Figure 7) using 1/4-20 x 1/2 screw

and 1/4-20 locknut (B) for rear hole. Use 1/4-20 x 1
screw (D) as shown. Tighten hardware.

2. Install strap (E) to screw (D) securing with 1/4-20

locknut (F).

Component Installation

INSTALL MOUNTING PLATE

1. Install mounting plate (A, Figure 5) to mower deck as

shown. Secure with 5/16-18 x 5/8 carriage bolts (C)
and 5/16-18 locknuts (A).

Figure 5. Install Mounting Plate
A. Mounting Plate
B. Locknuts, 5/16-18
C. Carriage Bolts, 5/16-18 x 5/8