Toro 91764SL User Manual
Special Tools
NOTE: Order special tools from the
TORO SPECIAL
TOOLS AND APPLICATIONS GUIDE (COMMERCIAL
PRODUCTS). Some tools may be listed in the
HydroJect 3000 Parts Catalog. Some tools may also be
available from a local supplier.
PRODUCTS). Some tools may be listed in the
HydroJect 3000 Parts Catalog. Some tools may also be
available from a local supplier.
Hydraulic Tester - With Pressure and Flow Capabilities (Fig. 9)
Flow Meter
Gauge
Gauge
Gauge
Load Valve
Outlet
Hose
Hose
High Pressure
Inlet Hose
Protector Valve
Low Pressure
Figure 9
You must have o-ring face seal (ORFS) adapter fittings
for this tester to use it on the HydroJect 3000.
for this tester to use it on the HydroJect 3000.
1. INLET HOSE: Hose connected from the system
circuit to the inlet side of the hydraulic tester.
circuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 - 1000 psi.
provide accurate reading at low pressure, 0 - 1000 psi.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000.
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the
hydraulic tester to be connected to the hydraulic system
circuit.
hydraulic tester to be connected to the hydraulic system
circuit.
HydroJect
™
3000
Page 4 - 7
Special Tools