Yazoo/Kees ZMKW52212 User Manual

English

-

18

SETUP AND ADJUSTMENTS

Uncrate machine.

1 - Top loop
1 - Left side post
1 - Right side post
1 - Hardware bag
    2 - Latch Pins w/lanyard
    6 - Cap screws
    6 - Centerlock nuts
    2 - Knobs
(all hardware Grade 5).
1.  Remove roll bar and parts bag from the box.
2.  Install roll bar side posts.
  a.  Locate the LEFT and RIGHT side posts.
  b.  Slide the left side post into the left side 

receiver on the frame, do the same on the 

right side.

  c.  Using the cap screws, two per post, align 

the holes in the side post with the frame 

receiver. Install the centerlock nuts finger 

tight to the side post bolts.

3.  Install roll bar top loop.
  a.  Align the holes of the top loop with the left 

and right side posts.

  b.  Slide the latch pins through the front hole 

on the left and right side to connect the top 

loop to the side posts and secure with the 

hairpin.

  c.  Insert cap screws through the rear hole on 

the left and right side. Install the centerlock 

nuts finger tight.

4.  Torque all hardware to 80 ft./lbs. (110 N•m).
5.  Install and tighten knobs against the side post.
6.  If ROPS has been installed correctly, the unit 

should fold to the rear of the machine when not 

in use.

LATCH PIN

½" CAPSCREW

KNOB

½" CENTERLOCK NUT

LEFT SIDE

POST

RIGHT SIDE

POST

TOP LOOP

½" CENTERLOCK

NUTS

½" CAPSCREWS