Husqvarna 03002 User Manual

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT

(See Fig. 34)

MOWER DRIVE BELT REMOVAL

•

Park tractor on a level surface. En gage parking brake.

• Lower attachment lift lever to its lowest position.
• Disengage belt tension rod (K) from lock bracket (L).

CAUTION: Belt tension rod is spring

loaded. Have a firm grip on rod and

release slowly.

• Remove screws (P) from mandrel covers (Q) and

remove covers.

•

Remove any dirt or grass clippings which may have accu-

mulated around mandrels and entire upper deck surface.

•

Remove belt from electric clutch pulley (M), both man-

drel pulleys (R) and all idler pulleys (V).

MOWER DRIVE BELT INSTALLATION

• Install belt around all mandrel pulleys (R) and around

idler pulleys (V) as shown.

• Install belt onto electric clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower

pulley grooves.
• Reassemble mandrel covers (Q). Securely tighten all

screws.

• Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring

loaded. Have a tight grip on rod and

engage slowly.

• Raise attachment lift lever to highest position.

TO REPLACE MOTION DRIVE BELT

(See Fig. 35)

Park the tractor on level surface. En gage parking brake.

For as sis tance, there is a belt installation guide decal on

bottom side of left footrest.

BELT INSTALLATION -
1. Install new belt from tractor rear to front, over the steer-

ing plate (H) and above clutch brake pedal shaft (J).

2. Pull belt toward front of tractor and roll belt around

electric clutch and onto engine pulley (G).

3. Pull belt toward rear of tractor. Carefully work belt

down around transmission cooling fan and onto the

input pulley (F). Be sure belt is inside the belt keeper.

4. Install belt on centerspan idler (E).
5. Install belt through stationary idler (C) and clutch ing

idler (D).

6. Reinstall anti-rotation link (B) on right side of tractor.

Tighten securely.

7. Reconnect clutch harness (A).
8. Make sure belt is in all pulley grooves and in side all

belt guides and keep ers.

9. Install mower (See “TO INSTALL MOWER” section in

this manual).

Fig. 35

Fig. 34

BELT REMOVAL -
1. Remove mower (See “TO REMOVE MOWER” section

in this manual).

NOTE: Observe entire motion drive belt and position of all

belt guides and keepers.
2.  Disconnect clutch wire harness (A).
3.  Remove anti-rotation link (B) on right side of tractor.
4.  Remove belt from stationary idler (C) and clutching

idler (D).

5. Remove belt from centerspan idler (E).
6. Pull belt slack toward rear of trac tor. Carefully re-

move belt up wards from trans mis sion input pulley and

over cooling fan blades (F).

7. Remove belt downward from engine pulley and

around electric clutch (G).

8. Slide belt toward rear of tractor, off the steering plate

(H) and remove from tractor.

electric

02953