Husqvarna 03002 User Manual

• Raise 

hood.

•  Pull bulb holder out of the hole in the backside of the 

grill.

•  Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

• Close 

hood.

Loose or damaged wiring may cause your tractor to run 

poorly, stop running, or prevent it from starting.
•  Check wiring.  See electrical wiring diagram in the 

Repair Parts section.

Replace with 20 amp automotive-type plug-in fuse.  The 

fuse holder is located behind the dash.

• Raise 

hood.

•  Unsnap headlight wire connector.
• 

Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•  To replace, reverse above procedure.

02778

The throttle control has been preset at the factory and 

ad just ment should not be necessary. If adjustment is nec-

 es sary, see engine manual.

The choke control has been preset at the factory and ad just-

 ment should not be necessary. If adjustment is necessary, 

see engne manual.

Your carburetor is not adjustable. If your engine does not 

operate properly due to suspected carburetor problems, 

take your tractor to an authorized service center for repair 

and/or adjustment.

Should your transmission require removal for service or 

re place ment, it should be purged after reinstallation and 

before operating the tractor.  See “PURGE TRANS MIS SION” 

in the Operation section of this manual.

•  Lift hood to raised position.
•  Remove terminal cover.
•  Disconnect BLACK battery cable then RED battery 

cable and carefully remove battery from tractor.

•  Install new battery with terminals in same position as 

old battery.

•  Reinstall terminal cover.
•   First connect RED battery cable to positive (+) battery 

terminal with bolt and nut as shown. Tighten securely.

• 

Connect BLACK grounding cable to negative (-) bat tery 

terminal with remaining bolt and nut. Tighten securely

• Close 

hood.