Sony V6 User Manual
28
Parts Identification
For details on how to insert the batteries, see
“Power Supply” on page 34.
“Power Supply” on page 34.
g + (+ selection) / – (– selection/reset)
buttons
Press these buttons to set the transmission
channel, frequency, or attenuation level of
the input signal.
The “–” button resets the accumulated use
time to “00:00”.
channel, frequency, or attenuation level of
the input signal.
The “–” button resets the accumulated use
time to “00:00”.
h SET button
Press to change and enter display
parameters.
Press to change and enter display
parameters.
For details, see “Transmitter Settings” on page 46.
i Display section
A
AF (audio frequency) indication
Appears whenever the input audio signal is
stronger than the reference level.
stronger than the reference level.
B
RF (radio frequency) indication
Appears during signal transmission from
the antenna.
the antenna.
C
RF (radio frequency) level
indication
indication
Shows the RF output level setting.
For details, see “Setting the RF output power level”
on page 47.
on page 47.
D
BATT (battery) indication
Shows the battery condition.
For details, see “Battery indication” on page 35.
E
CH (channel) indication
Shows the transmission channel. Each time
you press the SET button in transmission
mode, the channel indication changes as
follows.
you press the SET button in transmission
mode, the channel indication changes as
follows.
For details, see “Transmitter Settings” on page 46.
Hand-held microphone
(UTX-H2)
(UTX-H2)
The channel indication (E) for U30
model is shown.
model is shown.
Transmission
channel
channel
Transmission
frequency
frequency
Accumulated
use time
use time
Attenuation
level of the
input signal
level of the
input signal
The channel/frequency indications for
U30 model are shown.
U30 model are shown.
Press
the
SET
button.
the
SET
button.
The rear side of
the battery
compartment
the battery
compartment