Roland XV-88 User Manual
216
Troubleshooting
Sound Is Distorted
• If the sound is distorted for specific Patches or parts, lower
• If all sounds are distorted, use the VOLUME slider to
lower the volume level.
Pitch Is Incorrect
Is the tuning of the XV-88 incorrect?
• Check the Master parameter (SYSTEM/TUNE/SYSTEM
Has the pitch been changed by pedal
operations or by Pitch Bend messages
received from an external MIDI device?
operations or by Pitch Bend messages
received from an external MIDI device?
• If you are in Performance mode, access the INFO display
(PERFORM/INFO) to check the settings of the Pitch
Bend Message parameter (Bnd), and make the
appropriate settings (p. 56).
Bend Message parameter (Bnd), and make the
appropriate settings (p. 56).
Have the Coarse Tune or Fine Tune
parameters been set for specific Parts?
parameters been set for specific Parts?
• Check the Coarse parameter and Fine parameter
Effects Do Not Apply
Are [MULTI], [CHORUS], and [REVERB] turned
off?
off?
Are the various effect settings correct?
• If the send levels to each effect are at 0, effects are not
• Even with send levels to each effect set at 0, effects are
not applied if the Multi-effects Dry Send Level (p. 116),
the Chorus Level (p. 158), or the Reverb Level (p. 160) is
set to 0. Check each setting.
the Chorus Level (p. 158), or the Reverb Level (p. 160) is
set to 0. Check each setting.
• If Output Assign is set to other than MFX, the Multi-
• If Output Assign is set to PATCH for each Part of the
Performance, the sound will be output according to the
Output Assign settings of the Patch (for each Tone)
which is assigned to those Parts (p. 113). This means that
if Output Assign for the Patch (each Tone) is set to other
than MFX, the Multi-effects sound will not be output (p.
109).
Output Assign settings of the Patch (for each Tone)
which is assigned to those Parts (p. 113). This means that
if Output Assign for the Patch (each Tone) is set to other
than MFX, the Multi-effects sound will not be output (p.
109).
Sounds Are Interrupted
If you attempt to play more than 128 voices at
once, sounds will be interrupted (p. 23).
once, sounds will be interrupted (p. 23).
• Increase the Voice Reserve setting for Parts that must not
When You Play the Keyboard,
Notes Do Not Stop
Notes Do Not Stop
Is the pedal polarity of the Hold Pedal
reversed?
reversed?
• Check the Polarity parameter (SYSTEM/CONTROL/
Exclusive Messages Are Not
Received
Received
Is the instrument set to receive Exclusive
messages?
messages?
• Set the Rx Sys.Excl parameter (SYSTEM/MIDI/SYSTEM
Does the Device ID number of the transmitting
device match the Device ID number of the XV-
88?
device match the Device ID number of the XV-
88?
• Check the Device ID parameter (SYSTEM/MIDI/
* If you wish to rewrite the User memory settings by System
The XV-88 Does Not Transmit
MIDI Data
MIDI Data
Is the rear panel COMPUTER switch set to the
correct position?
correct position?
• If you wish to transmit this unit data via the
COMPUTER connector, set the COMPUTER switch to
Mac or PC, depending on the computer or software you
are using (p. 208).
Mac or PC, depending on the computer or software you
are using (p. 208).
• When the COMPUTER switch is set to MIDI, the XV-88
will not transmit data from the COMPUTER connector.
In this case, data will be transmitted from the MIDI OUT
connector.
In this case, data will be transmitted from the MIDI OUT
connector.