Grizzly G0758 User Manual

Model G0758 (Mfd. Since 2/14)

-19-

3. Rotate variable-speed knob to lowest setting.

4. Rotate high/low gearbox knob to low "L" gear

setting (see

Figure 17).

Note: When switching between gears, it may
be necessary to rotate spindle by hand so
gears will align and engage.

Figure 16. Location of mill/drill controls (front).

Figure 17. Gearbox knob rotated to low setting.

High/Low

Gearbox

Knob

OFF Button

ON Button

Variable-

Speed

Knob

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.

If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The

Troubleshooting table in the

SERVICE section of this manual can help.

DO NOT start machine until all preceding

setup instructions have been performed.

Operating an improperly set up machine

may result in malfunction or unexpect-

ed results that can lead to serious injury,

death, or machine/property damage.

Serious injury or death can result from

using this machine BEFORE understanding

its controls and related safety information.

DO NOT operate, or allow others to operate,

machine until the information is understood.

To test run mill/drill:

1. Make sure all tools and objects used during

setup are cleared away from machine.

2. Press OFF button (see Figure 16). This

will help prevent unexpected startup when
machine is connected to power.

5. Connect mill/drill to power supply.

6. Press ON button. Spindle should begin to

rotate clockwise (as viewed from top), and
machine should run smoothly with little or no
vibration or rubbing noises.

7. Press OFF button.

8. Open chip guard half way and press ON but-

ton. Machine should not start.

—If machine does start (with chip guard

opened  half  way),  press  OFF  button  and
immediately disconnect power to machine.
The chip guard safety feature is not work-
ing  correctly.  This  safety  feature  must
work properly before proceeding with regu-
lar  operations.  Refer  to

Troubleshooting

table in this manual.

Congratulations! The

Test Run is complete.

Continue to

Spindle Break-In.