Zebra Technologies MP User Manual

UMAN-Charge

16

Charging

Trickle
Charging
Temperature
too high/low

The UCN72 is a wall mounted fast charger with universal

110 to 230, 50-60 Hz. VAC input. Multiple A.C. plug configu-
rations comply with most interna-
tional standards.   This charger is
used with the Encore and Cameo
series printers equipped with
NiMH batteries.  The UCN72 will
charge a battery pack as fast as its
charge level will allow, and then
switch over to a trickle mode to
maintain the charge at its maxi-
mum.  Refer to the table below for
part numbers.

Plug the UCN72 into the appro-

priate A.C. wall receptacle, then
insert the charge cable into the
battery pack charger jack.

The charger LED will indicate the status of the

charger as follows:

• A steady light indicates the battery pack is

undergoing a fast charge.

• A slow blinking light indicates the charger is

in trickle mode.  The battery pack is ready for
use.

• A rapidly blinking light indicates a problem

with the battery pack.  The battery may have an
internal short, or its charge monitoring circuitry
may be malfunctioning.  The battery pack
should not be used any further.