Grizzly G9860 User Manual
Extreme series Jointer (Mfg. since 9/11)
-47-
3. With the use of a magnet or an assistant,
make sure that the straightedge stays flat
against the full length of its contact with the
outfeed table during the following steps.
against the full length of its contact with the
outfeed table during the following steps.
4. use the handwheel to adjust the infeed table
as close as possible to the straightedge, then
look closely for any gaps between the infeed
table and the straightedge. repeat this pro-
cess on the front of the infeed table.
look closely for any gaps between the infeed
table and the straightedge. repeat this pro-
cess on the front of the infeed table.
— if there are no gaps as the straightedge is
positioned on both the back and front of
the tables, then the infeed table is parallel
with the outfeed table and the cutterhead—
thus, no further adjustments are required.
proceed to
the tables, then the infeed table is parallel
with the outfeed table and the cutterhead—
thus, no further adjustments are required.
proceed to
Step 7.
— if there are gaps between the straightedge
and the infeed table, make a note of how
much and where the gaps are, then pro-
ceed to
much and where the gaps are, then pro-
ceed to
Step 5.
Note: To access the table adjustment bolts
on the back side of the infeed table, remove
the back table cover.
on the back side of the infeed table, remove
the back table cover.
5. use the same process you performed in Step
9 on page 46 to raise or lower the left or right
end of the infeed table to eliminate the gaps.
adjust the adjustment bolts equally on each
side for the targeted end of the table, one
after the other, in very small increments (see
end of the infeed table to eliminate the gaps.
adjust the adjustment bolts equally on each
side for the targeted end of the table, one
after the other, in very small increments (see
Figure 73).
6. repeat Steps 4–5 until the infeed table is
completely parallel to the outfeed table, which
will also make it parallel to the cutterhead.
will also make it parallel to the cutterhead.
7. if the table adjustment cap and set screws
are loose, re-tighten them and re-install the
previously removed parts.
previously removed parts.
8. loosen the screw that secures the depth of
cut pointer (see
Figure 74), adjust the pointer
to "0", then re-tighten the screw.
>c[ZZY
6Y_jhibZci
7daiAdXVi^dch
GZVg
;gdci
AZ[i
G^\]i
Figure 73. locations of the infeed table
adjustment bolts.
9. if your jointer uses a knife-style cutterhead,
re-adjust the knife heights as instructed in the
adjusting/Replacing cutterhead Knives
subsection on
subsection on
page 39.
Figure 74. depth of cut scale and pointer.