Kodak ESP 5260 User Manual

6

You need:

• A laptop or desktop computer equipped with a network interface card or 

wireless networking support. 

• A working 802.11 wireless network. Kodak recommends that you use a wireless 

access point/router that uses Dynamic Host Configuration Protocol (DHCP).

• Your network name (SSID - Service Set Identifier). You can obtain your SSID 

from the wireless access point, most commonly a router, using the router’s 
embedded Web server. See the manufacturer’s documentation provided with 
your wireless system for more information.

• Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access 

(WPA/WPA2) passphrase.

• To 

 temporarily disable your firewall until the printer is successfully 

installed and communicating.

For assistance with any of the items listed above, contact your Internet service 
provider or your network administrator.

You can use the WiFi Setup Wizard on the printer to connect to your wireless 
network. Read the following procedures and use the one that is appropriate for your 
network setup.

 to determine what is needed to connect your printer to the 

network. For assistance, contact your Internet service provider or your network 
administrator.

To connect to a listed network using the WiFi Setup Wizard: 

1. Press 

.

2. Press 

 to select 

, then press 

.

3. With

selected, press 

.

NOTE:  The Wi-Fi radio is turned on automatically when you select WiFi Setup 

Wizard.

The printer searches for available wireless networks within range, then displays 
the list in order of signal strength. For example: