Xerox 7232 User Manual

Select [IPv4 – Gateway Address], and then [Change Settings].

NOTE: If you do not wish to set the gateway address, leave this field blank.

Using the same method as in step 6, enter the Gateway Address.

Select [IPv4 – IP Filter], and then [Change Settings].

Select [Enabled] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

Use PCONSOLE or NetWare Administrator (NWADMIN) to create a print queue, print 
server and printer, and assign the respective objects. For information on how to use 
PCONSOLE or NWADMIN, refer to manual which comes with NetWare.

There are two ways to type the name: typeable (OU, O, etc.) and typeless. The user 
must use the typeable name in order for it to work.

Example: ou=xxxx.o=yyyy.c=zzzzz

When using in the PSERVER mode, set as follows.

•

Printer server name – Use the same device name as the target printer.

•

Printer location – Set as Auto Load.

•

Printer Type – Set as Parallel.

•

Parallel Setting – Set as Auto Load.

For NetWare 5, only NWADMIN is available for use.

Install the PCL print driver on the NetWare client computer. Refer to the HTML 
document on PCL Print Driver CD-ROM.

To make sure that the machine has been installed on the network correctly, submit a 
test print from each client workstation. Perform the following steps.

Open a document on a client workstation.

Select the machine as the printer.

Print the document on the machine and verify that it prints correctly.