Xerox 7428 User Manual
Network Management
WorkCentre 7425/7428/7435
System Administrator Guide
System Administrator Guide
46
TCP/IP LPD Enablement
To support TCP/IP printing through the computer's LPR port in the case of Windows XP, the LPD (Line
Printer Daemon) must be enabled at the printer.
Printer Daemon) must be enabled at the printer.
Changing LPD Settings at the Printer
To view or change the printer's LPD setting, perform the following steps:
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. When the Port Settings menu displays, press the selection line labeled LPD.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the LPD selections menu displays, note that you have a choice of setting selections by
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. When the Port Settings menu displays, press the selection line labeled LPD.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the LPD selections menu displays, note that you have a choice of setting selections by
numbered horizontal lines, with the current status of each setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the selection,
to access available settings press the Change Settings button in the lower right corner of the touch
screen.
upper right corner of the screen returns you to the Port Settings menu. After pressing the selection,
to access available settings press the Change Settings button in the lower right corner of the touch
screen.
Port Status (LPD Enablement)
1. On the LPD selections menu, press the selection line labeled Port Status.
2. Press the Change Settings button.
3. On the LPD Port Status screen, note which of the two buttons is highlighted as the current setting
2. Press the Change Settings button.
3. On the LPD Port Status screen, note which of the two buttons is highlighted as the current setting
for LPD Enablement. The available settings are Enabled or Disabled. For the LPD to function, it
must be set to Enabled.
must be set to Enabled.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
5. To exit the screen, without making any changes, press the Cancel button.
LPD Port Number
1. On the LPD selections menu, press the selection line labeled LPD Port Number.
2. Press the Change Settings button.
3. Note the setting of Port 515, which is the recommended, default value. To change the setting, use
2. Press the Change Settings button.
3. Note the setting of Port 515, which is the recommended, default value. To change the setting, use
the keypad displayed on screen.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
5. To exit the screen, without making any changes, press the Cancel button.