Xerox 701P42722_EN User Manual

As the machine supports EtherTalk protocol, you can print from Macintosh.

NOTE: You will need the optional PostScript Kit to use EtherTalk for printing.

The machine supports a Macintosh or Power Macintosh with the following OS:

•

Mac OS 7.5 or later, 8.x, 9.x, or Mac OS X 10.2.

This section describes the installation procedure for using the machine in an EtherTalk 
Environment.

There are three stages required to install the machine on an EtherTalk network.

This requires the machine to be set up for EtherTalk.

Install the print driver (Adobe PS) for Macintosh.

A test print should be submitted to make sure that the machine has been installed and 
configured correctly.

This procedure is used to set up the network communication parameters of the 
machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to CentreWare Internet Services chapter on page 91.

Initially, boot the EtherTalk port.

Connect the machine to the network.