Xerox 8510 User Guide
Configuring the Network Address
Phaser® 8510/8560MFP Multifunction Product
2-6
Dynamic Methods of Setting the System’s IP Address
Set the system’s IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
on all Phaser printers.
■
DHCP
■
CentreWare IS
■
AutoIP
Enabling DHCP on the System
Verify that the system DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
CentreWare IS. DHCP is enabled by default.
Note:
To determine the system’s IP address, select
System Identification
. On the control
panel, press the System button, select
Information
, press the OK button, select
System
Identification
, and then press the OK button to view the system’s IP address.
See also:
Information Required for Manual IP Addressing
Information
Comments
Internet Protocol (IP) address of the system
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
a decimal number from 0–255.
Network Mask
If you are unsure, leave this blank; the system
chooses an appropriate mask.
chooses an appropriate mask.
Default Router/Gateway address
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
the host device from anywhere other than the
local network segment.