Toshiba e-STUDIO4500c/5500c User Manual
August, 2006
COMMON REMOVAL PROCEDURES
3-11
3.2.7 TONER HOPPER, FACE PLATE, PCU
Removing Toner Hopper, Face plate, PCU
Important: To avoid damaging the toner end sensor, make sure that the main
power switch is turned off and that the power cord is disconnected from the power
source before you remove the toner hopper.
power switch is turned off and that the power cord is disconnected from the power
source before you remove the toner hopper.
To remove the toner hopper:
1. Prepare an open space on the floor for the toner hopper.
2. Remove the screws of the toner hopper [A] (
2. Remove the screws of the toner hopper [A] (
x3).
3. Place your hands under the left and right corners of the toner hopper and
slowly pull it out on its rails until it stops.
I
MPORTANT
:
T
HE TONER HOPPER CAN EASILY SLIP OFF ITS RAILS
.
4. Press the release [B] to drop the support leg [C].
5. Confirm that the support leg is down and locked.
5. Confirm that the support leg is down and locked.
I
MPORTANT
:
A
LWAYS MAKE SURE THAT THE SUPPORT LEG IS DOWN AND LOCKED
BEFORE YOU REMOVE THE TONER HOPPER
.
6. Lift the toner hopper off its rails and set it on the floor.
CAUTION
The toner hopper is heavy! Lift it carefully, make sure that it
disengages completely from the rails on the left and right, and
then set it on the floor.
disengages completely from the rails on the left and right, and
then set it on the floor.
7. Push the toner hopper rails into the machine.
B132I006A.WMF
[A]
[B]
[C]