Toshiba 353 User Manual

6 - 18

e-STUDIO350/352/353/450/452/453

SCANNER

© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved

1.  When installing, fix the lens unit with

 the screws while pushing the unit to the
 rear side.

2.  Refer to “3.7.2 Lens Unit” in the Service
 Handbook for the adjustment method.

3.  Never attempt to loosen the screws

 (8 pcs.) of the lens unit denoted with

 arrows.

4.  Handle the unit with extra care. Do not  
 touch the adjusted area or lens. (Hold the
 unit as shown in the figure at right.)

[E]  Lens unit
(1)  Take off the lens cover (   Chapter 6.7 [B]).
(2)  Disconnect 1 connector from the SLG board.
(3)  Remove 2 screws and take off the lens unit.

(7)  Remove 1 screw. Lift up the exposure lamp

and take it off by pulling out toward you.

Make sure to hold only the black molded
part of the exposure lamp. Do not touch any
other part than this black molded part.