Sony FWD-42B2 User Manual

 GB

Network Port

Sets which terminal connects to the PC when the display is remote controlled by the 
PC.

• You cannot use REMOTE (STRAIGHT) and REMOTE (

) simultaneously.

• Select “LAN” when performing “IP Address Setup” or “Speed Setup”.

RS-232C

Select when connecting the display and PC via the REMOTE (STRAIGHT) 
connector.

LAN

Select when connecting the display and PC via the REMOTE (

) connector.

IP Address Setup

Sets an IP address to enable communication between the REMOTE (

) connector 

of the display and a device such as a PC connected with a LAN cable.
For details on how to make the settings, see the section of “Preparations for Using 
the Network Functions” (page 32).

Speed Setup

Sets a communication speed between the REMOTE (

) connector of the display 

and a device such as a PC connected with a LAN cable.
For details on how to make the settings, see the section of “Preparations for Using 
the Network Functions” (page 32).

Power On Delay

Adjusts the time from when the display is switched on until it actually turns on. Sets 
to “Off”, and 1 to 120 seconds. This suppresses a sudden load fluctuation to the 
power equipment when multiple units are connected.

HDMI Control

If you connect HDMI control compatible equipment to the HDMI input connector 
of the display, then the equipment can be controlled together.

You should use the remote control to switch on/off the display and connected 
equipment.

HDMI Control

Select “On” or “Off”. If you select “On”, then HDMI equipment control works, and 
it can be set to “Auto Device Off” and “Auto Display On”.

• If it does not work, also set HDMI settings on the connected equipment.
• To control it, the connected equipment must be HDMI control compatible, and 

it must be set to enable HDMI equipment control.

• Depending on the HDMI equipment, this may not operate together with this 

device in some cases.

Auto Device Off

Select “On” or “Off”. If you select “On”, then when the display’s power is switched 
off, the connected HDMI equipment’s power is also switched off together.

Auto Display On

Select “On” or “Off”. If you select “On”, then when connected HDMI equipment 
play or other control is selected, the display’s power also turns on together.

Displays the “Date”, “Model Name”, “Serial Number”, “Operation Time”, 
“Software Version” and “IP Address” of your display.

Select “Cancel” or “OK”. If you select “OK”, then all adjustments and settings reset 
to defaults.

The items included in the “Information” option and the “Index Number” will not be 
reset.