Sony FWD-42B2 User Manual

 GB

• The software specifications of this display are 

subject to change for improvements without notice.

• Screens shown by application software may differ 

slightly from the illustrations shown in this manual.

• For safety, connect the port of this display only to a 

network where there is no danger of excessive 
voltage or voltage surges.

• The steps described in this manual are guaranteed 

only for use under the following environment 
conditions.
Operating system: 

Microsoft Windows XP/Windows Vista/
Windows 7

Microsoft Internet Explorer 7.0 or later

• To ensure security on the network, setting a user 

name and password is recommended. For 
information on how to make these settings, see the 
section “Setup screen” (page 35).
For security settings, refer to your network 
administrator.

The display can be connected to a network with 
10BASE-T/100BASE-TX LAN cable.
When connected to a LAN, the IP addresses of the 
display can be set using one of the following two 
methods. Consult your network administrator 
regarding details about IP address selection.
• Assigning a fixed IP address to the display

Normally this method should be used.

• Automatically obtaining an IP address

If the network to which the display is connected has 
a DHCP server, you can have the DHCP server 
automatically assign an IP address. Note that in this 
case the IP address may change every time the 
display in which the display is installed is turned on.

Before setting the IP address, connect the LAN cable 
to the display to establish the network. After about 30 
seconds, turn on the display, and then start making the 
desired settings.

• Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States of America and/

or other countries.

• All other product names, company names, etc. mentioned in this manual are trademarks or registered trademarks 

of their respective owners.