Planar PX2211MW User Manual

 

 

6

 

Interface for Arm Applications   

The rear of this LCD display has four integrated 4 mm, 0.7 pitch 
threaded nuts, as well as four 5 mm access holes in the plastic 
covering as illustrated in Figure 1-4. These specifications meet the 
VESA Flat Panel Monitor Physical Mounting Interface Standard 
(paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997). 
Note: Please using M 4mm x 16mm (L) screw for this application.

 

 

Figure 1-4

 

 
Connecting the Display 

 

1.  Power off your computer.   
2.  Connect one end of the signal cable to the LCD Monitor’s VGA 

port or HDMI port. (See Fig 1-5) 

3.  Connect the other end of the signal cable to the VGA port, DVI 

port  or  HDMI  port  on  your  PC or video source: (DVD players, 
game consoles, set top boxes…etc) 

4.  Make sure connections are secure. 

Note: HDMI to HDMI cable is not supplied.

 

 

 

Figure1-5

 

Connecting the AC Power   

5.  Connect the power cord to the LCD Monitor.(See Fig. 1-6) 
6.  Connect the power cord to an AC power source. 

    Figure1-6 

Connecting the Audio Cable 

 

1.  Connect the audio cable to the "LINE OUT" jack on your PC's 

audio card or to the front panel's “AUDIO OUT” jack of your CD 
ROM drive. (See Fig. 1-7) 

Connect the other end of the audio cable to the LCD Monitor's 
"LINE IN" jack. 

Note:  If  a  HDMI  to  HDMI  cable  (not  supplied)  is  connected,  the 
audio cable is not required. A HDMI to HDMI cable will carry both 
audio/video signals.

 

Figure1-7

 

Connecting the USB up Stream Cable   

1. 

Connect the USB UP Stream Cable to the LCD Monitor. 
(See Fig. 1-8)   

Figure1-8

Power Jack 

Power Cord 

Audio Jack

HDMI D-SUB 

USB UP Stream