NEC PlasmaSync 3300 User Manual

The NEC PlasmaSync 3300 multimedia monitor is designed for convenient

installation with a wide variety of audio, the latest video components and many

data processing devices equipped with analog RGB output.

BNC jack terminals (VIDEO 1 and VIDEO 2) are provided for connection to two

separate external video components, plus S-VIDEO IN (VIDEO 1 and VIDEO

2) terminals for connection to S-connector VCRs.

THROUG-OUT (VIDEO 1 and VIDEO 2) are bridged output terminals that pro-

vide direct signal output of the component connected to VIDEO 1 IN, VIDEO 2

IN, S-VIDEO 1 IN or S-VIDEO 2 IN.

A D-SUB 15 PIN RGB multi-signal input connector automatically scans fre-

quencies between 15.5 kHz and 39.5 kHz. It is compatible with the IBM com-

patibles, and other IBM Compatible Graphics adapters plus any other data

processing devices equipped with analog RGB output.

1. Connect the external component video output to VIDEO 1 IN.

2. Connect the external component mono audio or stereo left channel audio

output to L AUDIO (MONO).

3. Connect the external component stereo right channel audio output to R

AUDIO.

4. Press VIDEO 1 on the terminal board or the VIDEO 1 key on the remote

control unit.

NOTE: S-VIDEO  IN terminals  will take preference over VIDEO IN termi-

nals when a component is connected to each terminal and VIDEO 1 or 2

selected.

1. Connect the external components with an S-connector output to S-VIDEO 1

IN.

2. Connect audio terminals as explained in VIDEO 1 INPUT connection previ-

ously.

3. Press VIDEO 1 on the terminal board or the VIDEO 1 key on the remote

control unit.

1. Connect the external component video output to VIDEO 2 IN.

2. Connect the external component mono audio or stereo left channel audio

output to L AUDIO (MONO).

3. Connect the external component stereo right channel audio output to R

AUDIO.

4. Press VIDEO 2 on the terminal board or the VIDEO 2 key on the remote

control unit.

1. Connect the external component with an S-connector output to S-VIDEO 2

IN.

2. Connect audio terminals as explained in VIDEO 2 INPUT connections previ-

ously.

3. Press VIDEO 2 on the terminal board or the VIDEO 2 key on the remote

control unit.

1. Connect THROUGH OUT 1 BNC or S-VIDEO 1 OUT to external compo-

nents to relay the signal input at VIDEO 1 IN, or S-VIDEO 1 IN.

2. Connect the external component mono audio or stereo left channel audio

input to L AUDIO.

3. Connect the external component stereo right channel audio input to R AU-

DIO.

4. Set the 75

Ω

/HIGH impedance select switch of the corresponding input sig-

nal on all but the last monitor to “HIGH” position. On only the last monitor set

it to “75

Ω

” position.

1. Connect THROUGH OUT 2 BNC or S-VIDEO 2 OUT to external component

to relay the signal input at VIDEO 2 IN or S-VIDEO 2 IN.

2. Connect the external component mono audio or stereo left channel audio

input to L AUDIO.

3. Connect the external component stereo right channel audio input to R AU-

DIO.

4. Set the 75

Ω

/HIGH impedance select switch of the corresponding input sig-

nal on all but the last monitor to “HIGH” position. On only the last monitor set

it to “75

Ω

” position.

NOTE:  The connection of three PlasmaSync 3300 monitors or more with

THROUGH OUT (VIDEO 1 or 2) terminals may degrade image quality.