EVGA 128-P2-KN01 User Manual

2.     Connect the other end of the audio cable to the input labeled “AUX” or “CD” on your motherboard 
        (if using onboard audio) or your soundcard (if using a dedicated sound card).

3.     If you do not have a four-pin audio connector available on your motherboard or sound card, 
        follow the directions below for External Cable.

External Cable:
1.     Connect the external audio cable to the LINE OUT jack on the EVGA Killer Xeno Pro bracket.

2.     Connect the other end of the external audio cable to the MIC IN jack on your motherboard 
        (if using onboard audio) or your soundcard (if using a dedicated sound card).

5.     Reinstall the cover on your computer and reconnect any cables that you removed earlier 
        in the installation.

6.     Plug an Ethernet Cable into the EVGA Killer Xeno Pro. (RJ-45 port)

7.     Power up your computer.

8.     Insert the driver installation CD or double click on the EVGA Killer Xeno Pro driver executable file that 
        can be downloaded at www.evga.com/support/drivers. The setup program takes over and will walk 
        you through the driver installation process.

9.     You may need to reboot your PC once the driver installation is complete.

If you are going to use the EVGA Killer Xeno Pro’s built in hardware voice chat, you will need to connect the 
included audio input/outputs correctly. There are two options for doing this, and internal, or external cable. 
NOTE: You only need to use one of the below two options.

Internal Cable:
1.     Connect the four-pin audio cable to the four-pin socket near the top of the EVGA Killer Xeno Pro card.