Quantum LTO-2 User Manual

Chapter 2  Installation and Quick Start
Installing an Internal LTO-2 Half-Height Tape Drive

14

LTO-2 Half-Height Tape Drive User’s Guide

2

By default, the internal LTO-2 Half-Height Tape Drive does not provide 

SCSI termination. If you use this default setting, you must place a SCSI 

bus terminator or a SCSI device with termination enabled at the end of 

the SCSI chain. See 

 for two examples of SCSI termination. 

The internal LTO-2 Half-Height Tape Drive provides terminator power if 

a jumper is placed on the termination power jumper pins (see 

Figure 6  Two SCSI 
Termination Examples 
for the Internal LTO-2 
Half-Height Tape Drive 

2

The Internal LTO-2 Half-Height Tape Drive include an RS-422 serial 

interface for tape libraries. The LTO-2 library interface uses an in-line 

shrouded and keyed 10-pin connector. This connector is located on the 

lower left side of the back of the drive (see 

). 

 shows pin 

assignments.

CSI Controller

mination enabled)

Tape drive

SCSI device

SCSI device

(termination

enabled)

(termination

disabled)

(no 

termination)

SCSI Terminator

SCSI Controlle

(termination enab

Tape drive

(no 

termination)