AMCC 9500S User Manual
Chapter 2. CLI Syntax Reference
36
3ware Serial ATA RAID Controller CLI Guide
For operating systems that support units larger than 2TB, there is no need to
set the policy to on unless you want the operating system to have multiple
smaller volumes.
set the policy to on unless you want the operating system to have multiple
smaller volumes.
If you use a 32-bit operating system, it is recommended that you keep the
policy on unless you know that your operating system supports disks that are
larger than 2 TB.
policy on unless you know that your operating system supports disks that are
larger than 2 TB.
When the autocarve policy is off, all newly created units will consist of one
single volume.
single volume.
Example
:
//localhost> /c0 show autocarve
/c0 Auto-Carving Policy = on
/c
x
show carvesize
This feature only applies to 9000 series controllers.
This command shows the maximum size of the volumes that will be created if
the autocarve policy is set to on. The carvesize can be set between 1024 GB
and 2048 GB. Default carvesize is 2048 GB (2 TB). For more information
see, “/cx show autocarve” above.
the autocarve policy is set to on. The carvesize can be set between 1024 GB
and 2048 GB. Default carvesize is 2048 GB (2 TB). For more information
see, “/cx show autocarve” above.
Example:
//localhost> /c0 show carvesize
/c0 Auto-Carving Size = 2000 GB
/c
x
show memory
This command reports the size of the memory installed on the controller.
Example:
//localhost> /c0 show memory
/c0 Memory Installed = 112MB
Note:
The 9500S controllers ship with 128 MBytes of cache, yet only 112MB
shows as memory installed. The other 16 MB is reserved for use by the controller.