GE LTC MAP User Manual

After securely mounting the LTC-MAP 2130 monitor, route the input and 

output cables back to the gland plate. 

CAUTION: Do not apply power to the LTC-MAP 2130 until all input and 

output cables are connected. 

The removable gland plate on the bottom of the LTC-MAP 2130 Monitor has 

pre-punched conduit holes (see Figure 3-2) and strain relief cable 

connectors.  Weep holes are provided to allow drainage of excess 

moisture.  

Additional holes can be drilled into the gland plate if required. Remove the 

plate by removing the two nuts and washers securing it to the monitor. The 

nuts are accessed from inside the monitor. 

CAUTION: Do not drill additional holes into the gland plate while it is installed 

on the monitor.  Metal chips can damage the circuit boards. 

10.25" (260 mm)

1.25"

(31.8 mm)

.875"

22.2 mm

1"

(25.4 mm)

4.194"

(106 mm)

Weep Holes

Strain Relief Connector

 

Figure 3-2: Gland Plate