Motorola MVME3100 User Manual
Chapter 5 Pin Assignments
MVME3100 Installation and Use (V3100A/IH1)
63
sATA Connectors (J28 and J29)
The MVME3100 has two sATA connectors. J28 is an internal type sATA connector located on
the planar and is intended to connect to a drive located on the board or somewhere inside the
chassis. J29 is an external type sATA connected located on the front panel and is intended to
connect to an external sATA drive. The pin assignment for these connectors is as follows:
the planar and is intended to connect to a drive located on the board or somewhere inside the
chassis. J29 is an external type sATA connected located on the front panel and is intended to
connect to an external sATA drive. The pin assignment for these connectors is as follows:
Headers
Boundary Scan Header (J24)
The 14-pin boundary scan header provides an interface for programming the on-board PLDs
and for boundary scan testing/debug purposes. The pin assignments for this header are as
follows:
and for boundary scan testing/debug purposes. The pin assignments for this header are as
follows:
Note
Pin 12 must be grounded in the cable in order to enable boundary scan.
Table 5-16. sATA Connectors (J28 and J29) Pin Assignments
Pin
Signal
1
GND
2
SATA_TX+
3
SATA_TX-
4
GND
5
SATA_RX-
6
SATA_RX+
7
GND
Table 5-17. Boundary Scan Header (J24) Pin Assignments
Pin
Signal
Signal
Pin
1
TRST_L
GND 2
3
TDO
GND 4
5
TDI
GND 6
7
TMS
GND 8
9
TCK
GND 10
11
NC
GND (BSCANEN_L)
12
13
BSCAN_AW_L
GND
14