Soyo SY-K7VME User Manual
SY-K7VME/K7VM333 Quick Start Guide
28
Is there a way to reprogram my BIOS after an unsuccessful flash?
No other way, you need to send back the BIOS ROM to your nearest SOYO branch for re-flashing.
No other way, you need to send back the BIOS ROM to your nearest SOYO branch for re-flashing.
I’m using a 133MHz FSB CPU, I cannot find the DDR 100MHz option in the BIOS, why?
The DDR speed should not be lower than the CPU FSB speed.
The DDR speed should not be lower than the CPU FSB speed.
VGA Issue
I cannot set my VGA to go higher than 16 color (640x 480).
1.
Make sure that you have installed the VIA 4 in 1 driver set.
2.
Install/ re-install the VGA driver.
After waking up from Suspend to RAM or Standby mode, the screen has no display but I can
hear the hard disk operating
hear the hard disk operating
1.
Install the VIA 4 in 1 driver set.
2.
Check the VGA card manufacturer for a driver update (if using a different video card then
the onboard video), and make sure the VGA card supports the Suspend to Ram function.
3.
Update your VGA card’s BIOS (in the case of a video card other then the onboard video).
Check your VGA card manufacturer for more details.
Audio Issue
I cannot get the sound working on my system.
1.
Check if the speaker wire is connected to the line out connector on the M/B.
2.
Check if the speaker power is powered on.
3.
Install the audio driver supplied on our driver disc.
4.
Check BIOS setup if “AC97 Audio” setup option is enabled.
5.
If sound already installed, check our website for audio driver updates.
The sound is working in my system, but when I play CD music from the CD-ROM, I do not get
any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN1 connector in the M/B
is not connected. See the beginning of this guide for the location of CDIN1.
any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN1 connector in the M/B
is not connected. See the beginning of this guide for the location of CDIN1.
The sound and everything else works fine except that the line-in and microphone do not work.
What is wrong?
What is wrong?
1.
Please go to sound properties and check if the line-in and microphone in are enabled and
not muted.
2.
Check if the Microphone is ok.
3.
When using 6 speakers the line-in and microphone channels are used for rear, center and
bass. 6-Channel audio and microphone/line-in can not be used at the same time.