Soyo SY-K7VME User Manual
SY-K7VME/K7VM333 Quick Start Guide
29
Hard disk/FDD/ CD-ROM issue
My Western digital HDD is not detected during boot-up.
Change the jumper settings to cable select or single.
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not.
1.
Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the peripherals. If your
system has other peripherals connected, like CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer, I get "floppy boot failure" and the LED on the floppy stays
on.
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust the "key
lock" or "notch") and use the end-connector of the cable (don't use middle one).
on.
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust the "key
lock" or "notch") and use the end-connector of the cable (don't use middle one).
For updated FAQs, please check
http://www.soyousa.com/support/