Belkin PM11-EC/RAMA User Manual

Award BIOS Setup Utility

Resume on PCI Event

If you are using the Wake-On-USB Keyboard/Mouse function

with a device that is connected to the USB 2.0 port, set this

field to Enabled. This function allows you to use a USB keyboard

or USB mouse to wake up a system that is in the S3 (STR -

Suspend To RAM) state.

You must also set this field to Enabled if your PCI card such as

LAN card or modem card uses the PCI PME (Power

Management Event) signal to remotely wake up the PC. Refer to

the cards documentation for more information.

Resume On LAN/Ring

This field allows you to enable the Wake-On-LAN and Wake-On-

Ring functions.

If you are using a LAN card that supports the remote wake
up function, set this field to Enabled. The will allow the network

to remotely wake up a Soft Power Down (Soft-Off) PC.

However, if your system is in the Suspend mode, you can wake

up the system only through an IRQ or DMA interrupt. Your

LAN card must support the remote wake up function. Refer

to Wake-On-LAN Connector in chapter 2 for more

information.

When enabled, the system will power-on to respond to calls

coming through an external or internal modem. Refer to Wake-

On-Ring Connector in chapter 2 for more information.

Resume on Alarm

Enabled When Enabled, you can set the date and time you

would like the Soft Power Down (Soft-Off) PC to

power-on in the Date (of Month) and Resume

Time (hh:mm:ss) fields. However, if the system is

being accessed by incoming calls or the network

prior to the date and time set in these fields, the

system will give priority to the incoming calls or

network.

Disabled Disables the automatic power-on function. (default)