Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-44

busyout tone-clock 

If the system technician presses 

HELP

 after entering "busyout tone-clock," the 

following message will be displayed:

 Enter tone/clock location: [cabinet(1-3];(carrier(A-E))

If an identifier greater than 3 (three) characters is entered, or the cabinet entered 
is not a digit (number), the following message will be displayed:

 Identifier invalid

If the carrier entered is invalid, the following message will be displayed:

 Invalid carrier specified

If the cabinet entered is not within the valid range of cabinets or the cabinet is not 
administered, the following message will be displayed:

 Cabinet number not assigned

If there is no tone/clock board at the specified location, one of the following 
messages will be displayed:

 Board not inserted

 Board not assigned

If the specified cabinet carrier location is that of a switch node, the following 
message will be displayed:

 Switch Node carrier specified; invalid command for SN carrier

If the cabinet carrier location entered is that of an EPN that is not available, the 
following message will be displayed:

 EPN is not available

If the tone/clock is active and the specified action is busyout, the following 
message will be displayed:

 Illegal Command for active object; use ’set’ to switch to standby

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

 ’login id’:’command’ has a command conflict

location

A "location" represents the physical position of the tone/clock to be 
busied out and is entered as "UUc" where "UU" represents the cabinet 
number, and "c" represents the carrier. A cabinet number (1 - 3) may 
be entered with or without a leading zero (0).