Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-45

busyout trunk 

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

 Command resources busy; Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

For the following output example, assume that the command that was entered is 
"busyout tone-clock 1a."

None.

This command will busyout a specified trunk group or trunk group member.

Port

The tone clock maintenance object will only display the cabinet 
and carrier of the desired tone/clock board.

Maintenance Name

The type of tone clock circuit pack that is being busied out which 
is TONE-PT, TDM-CLK and TONE-BD.

Alt. name

Not applicable.

Result

The result of the busyout -"PASS," "ABORT," "FAIL".

Error Code

A system-generated number that tells why the busyout failed or 
aborted. A detailed list of the codes can be in the 
"Busyout/Release Error Codes" section of this chapter.

 
 busyout tone-clock 1a                            SPE A

                            COMMAND RESULTS

   Port    Maintenance Name  Alt. Name   Result       Error Code
   01A     TONE-PT                       PASS
   01A     TDM-CLK                       PASS
   01A     TONE-BD                       PASS

 Command successfully completed