Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-93

disable synchronization-switch 

No defaults.

None.

If the system technician presses help after entering "disable synchronization" the 
following message will be displayed:

 Entry is not required

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

 ’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

 Command resources busy; Press CANCEL to clear,and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

If the disable synchronization command is successful, the following message will 
be displayed on the SAT:

 Command successfully completed

If the disable synchronization command is unsuccessful, the following message 
will be displayed on the SAT:

 Error encountered, can’t complete request

If the disable command is run and synchronization is currently disabled, the 
following message will be displayed on the SAT:

 Synchronization-switch already disabled

None.