Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-687

upgrade software 

If the SPE-select switches are thrown to prevent the SPE-interchange during a 
software upgrade, the following message is displayed:

SPE select switches thrown; upgrade complete only on standby

If the standby SPE is not in the standby mode and is busy running tests, the 
following message will be displayed:

Standby SPE busy with another task; 

for information use ’status system’

If the standby SPE has not completed initialization, the following message will be 
displayed:

Standby SPE memory not refreshed; Use ’refresh spe-standby’

If the active SPE cannot communicate with the standby SPE after the standby 
SPE is properly upgraded, the following message will be displayed:

Upgrade failed; no communication with 

standby after new software booted

If the SPE-interchange failed and the new software cannot be run in the active 
SPE, the following message is displayed:

Software upgrade failed, could not perform an interchange

The following is the output of a successful simplex upgrade upon entering the 
"upgrade software" command:

 
 INITIATING SOFTWARE UPGRADE
 MEM-CARD CHECKSUMPASSED
REPROGRAMMING MTPPASSED
ERASING MEMORYPASSED
REPROGRAMMING SPEPASSED
FLASH TEXT CHECKSUM       PASSED
 UPGRADE COMPLETE
 <beep>
 REPLACE SOFTWARE MEM-CARD WITH TRANSLATION MEM-CARD
 <beep>