Advantech PCA-6186 User Manual
37
Chapter 3
3.6.13 UART Mode Select
This item allows you to select UART mode. The choices: IrDA, ASKIR,
Normal.
Normal.
3.6.14 RxD, TxD Active
This item allows you to determine the active of RxD, TxD. The Choices:
“Hi, Hi,” “Lo, Lo,” “Lo, Hi,” “Hi, Lo.”
“Hi, Hi,” “Lo, Lo,” “Lo, Hi,” “Hi, Lo.”
3.6.15 IR Transmission Delay
This item allows you to enable/disable IR transmission delay. The
choices: Enabled, Disabled.
choices: Enabled, Disabled.
3.6.16 UR2 Duplex Mode
This item allows you to select the IR half/full duplex funcion. The
choices: Half, Full.
choices: Half, Full.
3.6.17 Onboard Parallel Port
This field sets the address of the on-board parallel port connector. You
can select either 3BCH/IRQ7, 378H/IRQ7, 278H/IRQ5 or Disabled. If
you install an I/O card with a parallel port, make sure there is no conflict
in the address assignments. The CPU card can support up to three parallel
ports, as long as there are no conflicts for each port.
can select either 3BCH/IRQ7, 378H/IRQ7, 278H/IRQ5 or Disabled. If
you install an I/O card with a parallel port, make sure there is no conflict
in the address assignments. The CPU card can support up to three parallel
ports, as long as there are no conflicts for each port.
3.6.18 Parallel Port Mode
This field allows you to set the operation mode of the parallel port. The
setting “Normal” allows normal speed operation, but in one direction
only. “EPP” allows bidirectional parallel port operation at maximum
setting “Normal” allows normal speed operation, but in one direction
only. “EPP” allows bidirectional parallel port operation at maximum
Figure 3.6: Integrated peripherals (2)